The doorbells are easy to install and feature a variety of features such as motion detection, two-way audio, live video streaming, and automatic recording. Ring doorbells are an innovative security system designed to give homeowners peace of mind when it comes to protecting their home. You can also open the Ring app and check the battery level there. If the light is yellow or red, then your battery needs to be recharged. If the light is solid green, then your battery is charged and ready to go. To start, press the button on the front of the doorbell and wait for the LED light to appear. How to Optimize Your Ring Doorbell BatteryĬhecking the battery level on your Ring Doorbell is easy.Checking the Battery Level Using the Ring App.Benefits of Checking Your Ring Doorbell Battery.If you have tried everything and nothing works, please contact GARO support (do not forget the part number). This box/bottom card is the source of the fault and must be replaced with a new one. Now connect to one wallbox at a time until the white flash light comes back on. ![]() If NO, divide again, continue until the white flash ceases. Check if the white flash light disappears. To trace faulty wallboxes that can disrupt the entire cluster -> Split the cluster in half by dividing the “Data link” bus in the middle.Check that the Modbus cabling is not damaged or poorly connected anywhere in the “Data link” circuit (start tracing on the Modbus cabling between the last working and first non-functioning wallbox).Check that the other boxes have this set to “OFF”. ![]() Make sure that SW1->DIP6 is set to “ON” on the first and last wallboxes in the Modbus loop (The Data link circuit connects master with slaves).If only one or more slaves in a cluster exhibit this behaviour: Check FW on the master (unstable to the external meter in FW versions under 100).Which cabling has been used? -> Twisted pair is the minimum requirement, but shielding is recommended in installations with a risk of interference.If it does not flash, the meter and wallbox are not communicating. Make sure that the RX/TX symbol flashes in the display on the meter (3-phase only).Check that the external meter has voltage and that the address is set to “100”.If the master box + slaves exhibit this behaviour: Wallbox enters emergency power mode and delivers a maximum of 6 A to the vehicle. If you have tested everything and nothing works, contact GARO support (Do not forget the M number).ĭLM inoperative. If it starts, update/replace the WLAN module. Try removing the WLAN module and see if charging starts without this.Check on the web interface (WLAN only) that charging is not blocked.You should have the voltage on when you do this and press and hold until it beeps once, you should then release it and then wait about 10-15 minutes) Reset the slave on SW3 on the bottom card (located at the bottom of the charger.If control voltage is present replace the contactor.3 from the top of the quick connector on the bottom card) If there is no control voltage, check the connection of contactor control switch (A1 should be connected to port no.Check that the operating voltage is 220-230 V between A1 and A2 on the contactor. The contactor does not operate for some reason.3 from the top of the quick connector on the bottom card). Check that the contactor control switch is not connected incorrectly (A1 should be connected to port no. ![]() The car is connected but does not charge.
0 Comments
Leave a Reply. |